Original learning worksheet — How to check 3D model scale before sharing a mesh
Created by thecreatingco, October 10, 2026.
Example values and planning notes; not an app export, importable project, scan or measured benchmark.
You may reuse and modify this original worksheet, including commercially. No external-image rights are granted.

Long edge | 100 mm | Measure this edge first | Observed: __________ | Next decision: __________
Short edge | 50 mm | A second edge should have the same scale ratio | Observed: __________ | Next decision: __________
Depth | 20 mm | Check the thin axis independently | Observed: __________ | Next decision: __________
Imported long edge | 0.1 units | Consistent with metres only if destination units are metres | Observed: __________ | Next decision: __________

Review steps:
1. In Form make a small object with one deliberately known edge. Keep a note of the intended units outside the project.
2. Export through the current workspace controls. Retain the editable project and the original export separately.
3. Open the file in its destination and measure all three axes. If every axis is 1000 times smaller, investigate units before stretching individual vertices.

Decision note: For this example, a measured 0.1 metres equals 100 mm. A measured 0.1 mm fails the intended size. A visual preview cannot establish tolerances, structural performance or fabrication readiness.

My source/file: __________
Current browser/app version: __________
Checked on: __________
Saved copy location: __________
Output check and remaining uncertainty: __________